Irix > Installation/Update
Indigo: Autoboot failed
Beth:
Was ist:
--- Code: ---
Cannot load scsi(0)disk(1)rdisk(0)partition(0)/unix
Text start 0x4000, size 0x8dfb2c00 dosn`t fit in a FreeMemory area.
Unable to execute scsi(0)disk(1)rdisk(0)partition(0)/unix: not enough space
Autoboot failed.
scsi(0)disk(1)rdisk(0)partition(0)/unix: not enough space.
--- Ende Code ---
???
Fehler beim Vorbereiten der Platte (fx, partition, volheader) oder setenv im PROM? Voll kann die Platte kaum sein wg. Minimalinstallation auf 4GB
grüßt,
der Charles
Hamster:
Hallo !
Hast Du vielleicht vergessen eine Swap-Partition einzurichten.
Wieviel Haupspeicher hat denn die Maschine ?
bis denne ...
Thomas
Beth:
96MB in der Indigo
was mich verunsichert ist, dass die Maschine beim Anschalten jedesmal "check device/cable.." moniert, mit der 4GBPlatte, [..] *snipp*
Auf ein Neues!
Platte war nicht richtig initialisiert/partitioniert. Wieso ist mir schleierhaft. Daten waren weg, 4GB verfügbar, dann als rootdisk partitioniert und nach dem Schreiben des volumen headers waren die userdaten wieder drauf und ich habs nicht bemerkt ::) - wie geht denn sowas ??
Beth:
Na fein, Maschine läuft - diese Nachricht kommt von
--- Code: ---
pinguin 1% hinv
CPU: MIPS R4400 Processor Chip Revision: 5.0
FPU: MIPS R4000 Floating Point Coprocessor Revision: 0.0
1 150 MHZ IP20 Processor
Main memory size: 96 Mbytes
Secondary unified instruction/data cache size: 1 Mbyte on Processor 0
Instruction cache size: 16 Kbytes
Data cache size: 16 Kbytes
Integral SCSI controller 0: Version WD33C93B, revision C
Disk drive: unit 1 on SCSI controller 0
Tape drive: unit 2 on SCSI controller 0: DAT
Disk drive / removable media: unit 5 on SCSI controller 0
On-board serial ports: 2
On-board bi-directional parallel port
Graphics board: GR2-Elan
Integral Ethernet: ec0, version 1
Iris Audio Processor: revision 10
--- Ende Code ---
:D
Dennoch, irgendetwas stimmt nicht, bekomme beim Einschalten und nach dem "Running power-on diagnostics" stets ein
--- Code: ---SCSI device/cable diagnostic *FAILED*
Check or replace: Disk, Floppy, CDROM, or SCSI Cable
Diagnostics failed.
[Press any key to continue.]
--- Ende Code ---
Danach gelange ich ins Maintainence Menue und kann das System ganz normal ohne weitere Fehlermeldung starten.. Wer kennt sowas?
Es grüßt. Charles
Hamster:
Ahoi !
Hast Du nen Abschlusswiderstand hinten dran ?
Was passiert, wenn Du alle Laufwerke entfernst ?
Meckert die Diagnose immer noch ?
Es könnte sein, dass eines der Flachbandkabel im Drivesled das Problem verursacht ...
bis denne ...
Thomas
Navigation
[0] Themen-Index
[#] Nächste Seite
Zur normalen Ansicht wechseln